My name is Robert, I have lived in the DFW area all my life and I am very familiar with the area. I have been an Independent Office Furniture Dealer for 18 years and I have been in the Industry for 23 years. I can easily perform Assembly and Installation of Furniture and Accessories of all sizes but my specialty is mounting TV’s, whiteboards and mirrors.
Inspect the surface area for holes, cracks or other problems and apply acrylic caulk to fill them in. Use a putty knife to smooth out the caulk and remove any excess to prevent bumps. For particularly thin or narrow crevices, you may have to use your finger to smooth out the caulk. Caulk contracts and shrinks, so apply a second layer once it's dried.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
You've got me very afraid now, I've been taken in a couple of times since I moved here. They take advantage of me because I am a single woman, not exaggerating! From gardeners to inside work. Wouldn't have house painted but I know my HOA will be after me soon, garage door is peeling and stucco needs repair. Got the $1500.00 deal, but paying more for extra work they say I need.
Some contractors work on time and material others on a firm contract. I would never hire the former and am leary of the latter. A contractor may low-ball a bid to get the job planning to make a killing on change orders. If you say good morning to them, they charge you extra for that. If the contract is not very, very specific and extensively fleshed out or if they display their change order schedule prominently on top, show them the door.
So sad that Angie's List requires the contractor be notified!! They have lost me as a client. If I'm dissatisfied and want to give an "F" rating (question/workers...I SHOULD NOT be intimidated into passing up an opportunity to explain my experience! There is NO WAY my contractor got an Aplus rating from over five hundred people....so someone was lying....yet I can't report that without the contractor knowing it? REALLY?
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
The perfect roller would hold a roomful of paint, leave the right amount of texture, wouldn't spray or fuzz, and would be easy to clean. Until somebody invents the ideal one, follow these tips to choose the right roller. "The longer the nap, the more paint the roller will hold, but it will also create more texture." says Dixon. "A 1/2-inch nap lamb's-wool roller holds plenty of paint without too much texture," says Dixon. "Less expensive rollers can work," says Span. "Just wash them first in dishwashing liquid to remove any stray fibers." Most of the pros we spoke with prefer 9-inch rollers over 18-inch models -- they are lighter, cheaper, and easier to use. Despite these shortcomings, Maceyunas swears by the wider roller. "The roller can do a whole wall in a few up and down strokes instead of in several dozen W and M strokes," he says.

House Painter Co

×